NOTE: FOR SAFE OPERATION
1. All winches should be installed so the user can readily see the pawl to ensure proper engagement.
2. The winch should be positioned so the pawl drops into the ratchet wheel by gravity.
3. Winches should never be installed so the user cannot see the pawl engagement or in a position where the user must hold the pawl to engage the ratchet tooth.
4. Weld on winches must be welded to the trailer frame. Minimum weld requirements are 1/4” fillet weld, 4” long on both sides of frame, and 1/8” penetration.
WARNING: Prop 65: Products supplied by CERTEX USA may expose you to chemicals including Nickel, which is known to the State of California to cause cancer. For more information, visit to www.P65Warnings.ca.gov.
Range from 500kg – 5.0t Meets or exceeds all international standards High quality alloy calibrated load chain Rugged steel body construction Drop forged & heat-treated alloy hooks Proof tested to 1.5 times rated capacity Lightweight and portable Safe reliable twin...
DNV GL Verification tested according to NORSOK R-002 Range from 250kg – 35.0t Available with slipping clutch overload protection Tested and certified for “fleeting”, “drifting” and “cross-hauling” applications up to 60° from the vertical without deration Available...
Range – 0.25 tonne to 2.0 tonne Reliable, fast, efficient, quiet and lightweight Greater than 5:1 factor of safety Suitable for Fleeting/Oblique pulling Certified for ATEX Category 3 – normal safety
TAH21M 2.0t/2.0t configuration TAH33M 3.0t/3.0t and 3.0t/6.0t configurations Two chain falls with hooks for alternate working Various hook options – standard, closed eye, grab and self-locking Integral load limiter Especially suitable for horizontal pulling Reliable,...
